Vinten Vector 70 - Page 63

63
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.4 Vector 70/70H Pan and Tilt Head - Pan Drag/Brake Mechanism
Item Part No Nomenclature Qty
1 3354-22 Pan drag lid (rivet bush) assembly 1
2 M005-513 Screw, button head, socket, M4 x 6 mm long 1
3 R200-004* Seal, bonded, M4, 4.5 mm ID x 7.0 mm OD x 1.0 mm thick 1
4 Q900H040* ’O’ ring, 4.75 in. ID x 0.0625 in. sect, Dowty 200-048-4460 1
5 3354-322 Trunnion right hand 1
6 3354-323 Trunnion left hand 1
7 3354-21* Pan friction shoe assembly 2
8 3354-321 Friction drum - pan drag, with: 1
NI M850-034 Threaded-insert, wire thread insert (helicoil), M8 x 1-1/2 diameters long 1
9 Q500-051* Omniseal, 2.127 in. shaft dia. x 3/32 in. nominal section 1
10 P200-229* Bearing, ball, radial, 45 mm ID x 58 mm OD x 7 mm long, open 1
11 M701-005 Circlip, external, standard, 8 mm shaft dia. x 0.80 mm thick 1
12 Q500-052* 'V'-Seal, to fit 6.5 to 8 mm shaft dia. 1
13 R900H019* ’O’ ring, 21.1 mm ID x 1.6 mm sect, Dowty 202-514-4460 1
14 M701-060 Fastener, push-on, reinforced, 3 mm shaft dia. x 0.25 mm thick 2
15 J532-167 Spring, compression, 3/4 in. free length, 1/4 in. hole dia., 7.9 lbf/in. rate 2
16 3354-38 Pan drag plate sub-assembly 1
17 3354-328 Disc 1
18 3354-27* Pan brake shoe bonding assembly 1
19 3354-319 Ring 1
20 M806-005 Pin, coiled-spring, 4 mm dia. x 12 mm long, hdp 2
21 M801-014 Pin, dowel, 6 mm dia. x 25 mm long 2
22 3354-316 Mounting plate, with: 1
NI L850-053 Threaded-insert, wire thread insert (helicoil), 3/8 in. BSW x 1-1/2
diameters long
4
23 M005-740 Screw, locking, cap head, socket, M4 x 18 mm long 8
24 M008-704 Screw, cap head, socket, M8 x 20 mm long 1
25 3354-29 Pan brake reaction plate bonding assembly 1
26 3354-318 Brake disk 1
27 3354-34 Thrust bearing assembly, pan unit 1
28 3354-333 Pan coupling screw 1
29 3354-308* Coupling (drag shoe assembly) 1