Vinten Vector 70 - Page 67

67
Contents
Previous
Page
First
Page
Next
Page
Previous
View
1 3354-441 Support cap (right hand) 70H new hole position 1
2 3354-250 Actuator rod 1
3 L701-082 Fastener, push-on, standard, 0.156 in. shaft dia. x 0.010 in. thick 1
4 3354-276 Pin (Pan brake arm / Fork end pivot) 1
5 3354-311 Link arm (Pan brake casting) 1
6 3354-313 Fork end 1
7 3354-312 Rocker arm (Pan brake) 1
3354-31 Spring sleeve assembly, pan brake, comprising:
8 3354-339 Stud 1
9 3354-338 Cup 1
10 M500-060 Nut, M3, standard (hex), full 1
11 3354-269 Washer 1
12 M600-007 Washer, plain, heavy, M6 1
13 M601-261 Spring, disc, 6.2 mm ID x 12.5 mm OD x 0.7 mm thick 20
14 3354-268 Pin 1
15 3354-272 Shim (brake link pivot) A/R
16 3354-248* Brake lever, pan 1
17 3354-273 Pin (Tilt brake arm con.) Link 1
18 3354-244 Link arm (Tilt brake) 1
19 3354-247*Brake lever, tilt 1
20 3354-275 Pin (Pan/tilt Link arm pivot) 1
21 3354-274 Pin (brake lever pivot) 1
23 3354-249 Connecting link 1
22 3354-270 Actuator rod 1
23 M004-807 Screw, grub, knurled cup point, socket head, M3 x 5 mm long 1
24 P001-018* Bearing, plain, du bush, 8 mm ID x 10 mm OD x 12 mm long 2
26 M006-705 Screw, cap head, socket, M5 x 20 mm long 1
27 M006-704 Screw, cap head, socket, M5 x 16 mm long 1
28 3354-24* Base housing (bonding) assembly (Fig 6.3)
29 M006-718 Screw, cap head, socket, M5 x 40 mm long 1
30 3354-246 Bell crank (Tilt brake) (Fig 6.10)
Fig 6.5 Vector 70/70H Pan and Tilt Head - Brake Lever Support Cap Assembly (Cont)
Item Part No Nomenclature Qty