Vinten Vector 70 - Page 75

75
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.8 Vector 70H Pan and Tilt Head - Balance Adjuster Assembly
Item Part No Nomenclature Qty
3354-55 Balance adjuster assembly (Vector 70H), comprising: 1
1 P603-003* Bearing, track roller, yoke type, 7 mm bore dia., 16 mm roller dia. x
7.8 mm roller width
4
2 3354-220 Shim (Roller axle) 8
3 3354-227 Track wiper 4
4 3354-226 Track wiper outer 4
5 3354-428 Roller axle (27 mm long) 2
6 P302-016* Bearing, ball, radial, 20 mm ID x 32 mm OD x 7 mm long, two seals 2
7 3354-447 Adjustment housing 1
8 M004-806 Screw, grub, knurled cup point, socket head, M3 x 4 mm long 5
9 3354-445 Adjustment carriage 1
10 3354-219 Roller axle (15 mm long) 1
11 3354-426 Adjustment thread 1
12 3354-231 Roller axle (18 mm long) 1
13 M701-004 ’E’-Clip, standard, 9.50 mm shaft dia. x 0.90 mm thick 1
14 P003-001* Bearing, plain flanged, plastic, 8 mm ID x 10 mm OD x 5.5 mm long 1
15 3354-213 Gear 1
16 M806-006 Pin, coiled-spring, 4 mm dia. x 16 mm long, mcp 1
17 3354-443 Lift off pin (flat end) 1