28
© 2011 Directed Electronics. All rights reserved.
Use one of the below methods to exit Smart Start mode:
• Perform the same steps you followed to activate Smart Start mode
• Turn the ignition On
• Press the brake pedal
The parking lights flash 5 times slowly to confirm the remote has exited Smart
Start mode.
➢ Low runtime alert
During remote start a message is sent three minutes before and then again at
one minute before the engine turns off. The 2- way remote plays tones as an
alert to reset the runtime if desired.
➢ Cabin temperature
Using the Responder LE you have the ability to check the temperature inside the
vehicle.
Press the button one-time, and then press and hold until the remote beeps,
and then release. The LEDs light up indicating the temperature range of the
vehicle.
95˚F and above
76˚F to 95˚F
56˚F to 75˚F
32˚F to 55˚F
32˚F and below
AUX
To Next Page
Loading...
