Virutex FC116U - Page 17

FC116U / Operating instructions - 17
INDEX
Specifications are subject
to change without prior
notice.
OPERATING INSTRUCTIONS
1 TECHNICAL INFORMATION 18
2 USE 18
3 MACHINE HANDLING
SAFETY INSTRUCTIONS 19
4 STANDARD UNIT 19
5 ASSEMBLING THE
CARRIAGE ADVANCE HANDLE 19
6 MOUNTING THE CUTTING TOOL 20
7 SWITCH 20
8 ADJUSTING THE TRIMMING WIDTH 20
9 ADJUSTING THE TRIMMING LENGTH 21
10 ADJUSTING THE TRIMMING DEPTH 21
11
MORTISING EDGE TRIMMING ON A DOOR 22
MEASURING AND TRACING REFRENCES 22
TRIMMING THE BOX FITTING 23
12.1 TRIMMING THE FITTING FOR THE FRONT PLATE
OF THE LOCK FOR A MAXIMUM "Nt" OF 170 mm 24
CHANGING THE TRIMMING 24
MEASURING, MARKING REFERENCE POINTS
AND PLACING THE FC116U ON THE DOOR 24
ADJUST THE TRIMMING PATH 24
ADJUSTING THE DEPTH OF THE TRIM 25
TRIMMING THE FITTING 25
12.2
TRIMMING THE FITTING FOR THE FRONT
PLATE OF THE LOCK FOR AN "Nt" OF MORE
THAN 170 mm 26
CHANGING THE TRIMMING 26
MEASURING AND MARKING 26
ADJUST THE TRIMMING PATH 26
ADJUSTING THE DEPTH OF THE TRIM 26
TRIMMING THE FITTING 27
13 DRILLING THE HOLES FOR
THE HANDLE AND KEY 28
ASSEMBLING THE TOOL FOR THE UC16I
TEMPLATE 28
POSITIONING THE TOOL AND PERFORATING 28
OPTIONAL DRILLING TOOLS 28
14 TRIMMING THE LOCKS FOR SEVERAL
DOORS 29
15 HORIZONTAL MORTISING 29
16
CORRECTIONS FOR OVERLAPPING DOORS 29
17 DUST COLLECTOR ATTATCHMENT 30
18 REMOVING THE SPLINE SHAFT 30
19 CHANGING THE BRUSHES 30
20 LUBRICATION AND CLEANING 30
21 OPTIONAL TOOLS AND ACCESSORIES 31
22 NOISE AND VIBRATION LEVEL 31
23 WARRANTY 31