To Next PageTo Next Page
Need help?Do you have a question about the Virutex FC116U and is the answer not in the manual?
Provides detailed technical specifications for the FC116U lock mortiser, including motor power and speed.
Explains the primary uses and applications of the FC116U portable lock mortiser.
Crucial safety guidelines for operating the FC116U machine safely and correctly.
Lists all the standard components and accessories included in the FC116U package.
Step-by-step instructions for assembling the carriage advance handle onto the machine.
Guide on how to correctly mount the mortising trimmer bit onto the machine.
Explanation of the machine's power switch and how to operate it safely.
Instructions for setting the machine to the correct trimming width.
Detailed steps for adjusting the machine's trimming length.
Guidance on setting the precise trimming depth for mortises.
Steps for performing edge mortising on a door.
How to measure and mark reference points on the door for accurate mortising.
Detailed steps for trimming the box fitting for the lock.
Trimming the front plate fitting for locks with a maximum 'Nt' of 170 mm.
Instructions on how to change the trimming setup for the lock front plate.
How to measure, mark, and position the machine on the door.
Adjusting the machine's path for precise trimming of the lock front plate.
How to accurately set the depth for trimming the lock front plate.
Steps for performing the actual trimming of the lock front plate.
Trimming the front plate fitting for locks with 'Nt' greater than 170 mm.
How to set up the machine for trimming when 'Nt' exceeds 170 mm.
Measuring and marking procedures for doors with larger front plates.
Setting the machine's path for trimming larger front plates.
Setting the trimming depth for larger lock front plates.
Detailed steps for trimming the top and bottom of the lock front plate.
Instructions for drilling holes for door handles and keys.
How to assemble the UC161 template tool for drilling.
Steps for positioning the drilling tool and performing the drilling.
Information on optional drilling tools available for the machine.
How to trim locks on multiple doors for consistent height.
Instructions for performing mortising operations in a horizontal orientation.
Adjustments needed for mortising doors with overlaps.
How to attach a dust collector to the FC116U trimmer.
Steps for removing and replacing the spline shaft.
Instructions on how to change the machine's carbon brushes.
Guidance on lubricating and cleaning the FC116U machine.
Details on optional bits and accessories available for the FC116U.
Information on the noise and vibration levels of the FC116U.
Information regarding the warranty period and terms for the FC116U.
General
