Virutex FC116U - Adjusting the Depth of the Trim; Trimming the Front Plate Fitting

FC116U / Operating instructions - 25
ADJUSTING THE DEPTH OF THE TRIM
• Raise the knob “W” (Figs. 15-18) to its maximum upper posi-
tion, turning it counter-clockwise.
• Check that the lock lever “J” (Fig. 15) is in the horizontal posi-
tion (advance depth disconnected).
• Loosen knob “K” (Fig. 16). Move the machine downwards,
gently pushing the motor with your hand until the bit just tou-
ches the edge of the door. Hold it in this position, tightening
knob “K” (Fig. 16).
• Place the front of the lock (Fig. 17) so that it is touching the
lower part of the motor support; move and fix the depth stop
“S3” (Figs. 16 and 17), trapping the front of the lock.
• Loosen knob “K” (Figs. 15-17) so that the machine rises to its
original position.
TRIMMING THE FITTING
• Check that the lock lever “J” (Fig. 15) is in the horizontal posi-
tion (advance depth disconnected).
• Connect the machine to the mains, switch on the motor, pres-
sing the lever “Y” (Fig. 18) and set the safety “Z” (Fig. 18).
• Turn the knob “W” (Figs. 17 and 18) until the motor support
touches depth stop “S3” (Fig. 18). When the tool reaches the
depth of cut planned for the front of the lock, move the carriage
advance crank handle “A” (Figs. 15 and 18) gently until it reaches
each of the two stops “S1” (Figs. 15 and 18) located at each end
of the carriage path, in a rocking movement.
If the fitting to be created is greater than 2 mm, it is advisable to
complete this process using two or three successive movements,
repeatedly using knob “W”.
• Return the knob “W” (Fig. 18) and the depth stop “S3” (Fig. 16)
to their initial position once the trim has been completed.
(Figure 15)
(Figure 16)
(Figure 17)
(Figure 18)
K
W
S1
A
J
rs
W
K
S3
W
K
S3
S3
W
A
Z
Y
S1
rs1