Restore Factory Settings
A factory restore erases the information and settings on your flash
light in an attempt to restore the device to its original manufacture
settings.
Long press [MENU] button, the display shows as follows. Press
confirmation button to restore the device to its original manufacture
settings
Using VISICO Transmitter (not included)
1. VC-818TX transmitter can trigger and control VISICO2 flash light
directly.
2.Attach a VC-16RX receiver on VISICO2 flash light, use VC-801TX,
VC-816TX and VC-16TX transmitter to trigger VISICO2 flash light.
Error Codes
E1:Temperature Transducer problem. Turn the unit OFF
immediately and contact the place where you purchase the flash.
E2: This error code can display after a long shooting session at high
output or rapid sequence. Flash will make alarm, reminding user to
cool it before operate it again. Turn OFF the flash and allow it to rest
30 minute. Overheating protection alarm will be active after 60
successive shoots.
E3:This error code will display when the internal voltage of the flash
is too high.Turn OFF the power immediately. After a few minutes, turn
on the flash again.If you still have the malfunction warning, turn OFF
the unit and contact the place where you purchased the flash.
E4:Internal charging problem. Turn off flash light immediately, and
contact the place where you purchased the flash.
E5:Flash is in low power, please charge the battery immediately.
Low voltage protection: Before battery running out, battery signal on
the LCD screen will blink. Please charge battery as soon as possible.
If not charge the battery in time, power of the flash will cut off
automatically when battery voltage is lower than 14V.
17
To Next Page
Loading...