Vision MAX Pro User Manual

Vision Max Pro User Manual118
© 2015 Vision Engraving Systems
Select the Engrave icon from the left side toolbar, then select the color for cutting in the Filter Layer
drop down box in the Filter by Color window (select Red for this example),
then select Engrave from the Cut Toolbox. The screen will show only objects in the color selected in the
Filter by Color window.
The page selection screen will re-appear, for this example, choose Current Page and select OK. The file
will be sent to the engraver. Make sure you have installed the cutter/beveler tool for this process and set
up the cutting depth as described in the previous section. When the file is complete, it should appear as
shown. (The outside/excess material was removed in the picture below for clarity)

Vision MAX Pro Specifications

General

Brand	Vision
Model	MAX Pro
Category	Engraver
Language	English