Vision MAX Pro User Manual

Vision Max Pro User Manual94
© 2015 Vision Engraving Systems
NOTE - It is recommended to use the Vacuum Chip Removal System in this application. The design of
the Vacuum Chip Removal System is to clear the debris away from the engraved material and prevent
the chips from scratching the surface of the material during operation, and/or getting trapped between
the nose cone and the material (when using the proximity sensor function) and causing the engraver to
not engrave to the proper depth.
When the file is complete, remove the material from the table. HINT - Use a light bristle brush to clean
out any debris that may remain in the engraved characters.

Vision MAX Pro Specifications

General

Brand	Vision
Model	MAX Pro
Category	Engraver
Language	English