Vitec Multimedia MGW Ace Decoder OG User Manual

MGW Ace Decoder OG
User Manual, Version 2.0 33
Parameter Description
(Optional)
Ethernet
Port
Select the Ethernet Port from which the channel is received.
Streaming
Protocol
Select SRT Rendezvous.
IP
Address
Type the public IP address of the incoming SRT stream (typically, this is the
firewall public IP address where the stream is sent from)
Port Type the same port than the one entered on the encoder side
Stream
Name
Type the stream name.
Latency Type the SRT latency to be used. The latency used will be the higher value
set in the encoder and decoder interface. The latency used must be
minimally 3 times the RTT time indicated in the SRT Statistics window.
Additional latency shall be added based on link packet loss percentage.
FEC Select the FECsupport.
SRT Rendezvous with MGW Ace Encoder
To start using SRT Rendezvous streaming between MGW Ace Decoder OG and MGW Ace encoder:

Set SRT Rendezvous mode on MGW Ace Encoder

Set SRT Rendezvous mode on MGW Ace Decoder OG.
 Set the MGW Ace Encoder Target Address byentering the public IP address of the firewall where MGW Ace
Decoder OG ishosted.
 Set the MGW Ace Decoder OG Target Address by entering the public IP address of the firewallwhere MGW Ace
Encoder ishosted.

Set the same target port on both MGW Ace Decoder OG and MGW Ace encoder.
 Start the MGW Ace Decoder OG by clicking Play.
For Pro-MPEG channel:
Parameter Description
Channel
Name
(Optional)
Enter a Channel Name to differentiate channels within the Channel list.
Channel name is optional.
Ethernet Port Select the Ethernet Port from which the channel is received.

Vitec Multimedia MGW Ace Decoder OG Specifications

General

Brand	Vitec Multimedia
Model	MGW Ace Decoder OG
Category	Media Converter
Language	English