vividtouch VTE-3200 - Page 36

36
Advanced
Settings
Auto Adjustment (Video
Mode)
Off or On
Image Position (Video
Mode)
Up, Dow n, Left, Right
-50, ... 0, ...50
Phase (Video Mode)
0, 1, 2 ... 63
Clock (Video Mode)
0, 1, 2 ... 100
IRFM
Off or On
Baud Rate
115200, 38400, 19200 or 9600
Smart Light Control
Off, DCR or Light Sensor
Wake Up from Sleep
VGA Only, VGA, Digital, RS232
or Never Sleep
Ethernet Setup
Enable network
No or Yes
Dynamic IP
Disable or Enable
Static IP
255.255.255.255 (0.0.0.0)
Subnet Mask
255.255.255.255 (0.0.0.0)
Gateway
255.255.255.255 (0.0.0.0)
DNS Address
255.255.255.255 (0.0.0.0)
Save Network Settings
No or Yes
Refresh
Refreshes dynamic IP information
Power Status Alert
No or Yes
Source Status Alert
No or Yes
Signal Status Alert
No or Yes
Load Default
Loads default network settings
Device MAC
Displays MAC information
Factory Reset
Yes or No
System
Channel Information Main Active Source / Signal Resolution and
Refresh Rate
Firmware Version
NOTE Default settings appear in bold type.
Figure 4-1. OSD Menu Structure