Wake Up from Sleep
By default, the display will enter power saving (Sleep Mode) if no signal is received for 5 minutes. Normally, the RS-232,
DisplayPort, and HDMI inputs are inactive in Sleep Mode, to save power.
To change the behavior of Sleep Mode, change the “
Wake up from Sleep
” setting in the “
Adv. Setup
” menu.
VGA Only
(default) – The RS-232, DisplayPort, and HDMI inputs are inactive when the display is in sleep mode. The
display will wake up when it receives a signal at the VGA input.
Digital, RS232, Ethernet
– The RS-232, DisplayPort and HDMI inputs stay active when the display is in sleep mode.
The display will wake up when it receives a signal at either of the DisplayPort, HDMI, or RS-232 inputs, or via LAN
connection.
To Next Page
Loading...
