If metal or liquid gets into the display, it may cause a fire or an electrical shock.
Don’t install or remove the power plug with wet hands.
This may cause an electrical shock.
If the display will not be used for a long period of time, unplug the display.
This may cause premature wear of electrical components or fire.
Don’t press on the LCD panel.
This may cause personal injury or panel damage.
Don't push or shake the display.
This may cause damage or injury.
If the glass of the display panel is broken, liquid may escape. Please don't touch the liquid.
If liquid get into your eyes or touches your skin, wash with the clean water and seek medical attention
immediately.
Precautions with the remote control batteries
Please only use approved AAA type batteries.
Please be sure to insert batteries by matching the + and -.
Don’t recharge, heat, disassemble, short or throw batteries into a fire.
Don’t mix a new battery with a used one.
Don’t mix different types of batteries together (only use the specified type). it may cause burn and
injury.
Cleaning
If dust has collected on the power plug, removed the plug from the outlet and clean off the dust.
Dust build-up may cause a fire.
Take off the power plug before cleaning.
Failure to do so may result in electrical shock or damage.
Cleaning the surface of the display
When the surface of the display becomes dirty, please wipe the surface lightly with a soft clean cloth.
If the surface requires additional cleaning, lightly moisten the cloth.
Do not to let any kind of liquid enter the display as it may cause electrical shock or damage.
Do not clean the display with alcohol, solvents or ammonia, as this could damage the display.
To Next Page
Loading...
