What to do if there is colour losing or no video signal output in HDMI display of VivoLink Controller?
If you are experiencing colour loss or no video signal output on your HDMI display when using the VivoLink Controller, the connecting cables may not be connected correctly or could be damaged. Check that the cables are properly connected and in good working condition.
Why I cannot control VivoLink VLHDMICTL1-MME Controller by control device through RS232 port?
If you are unable to control your VivoLink Controller via the RS232 port, it might be due to incorrect RS232 communication parameters. Ensure that the RS232 communication parameters are correctly configured.
What to do if VivoLink VLHDMICTL1-MME Controller is broken and cannot be controlled by control device through RS232 port?
If you cannot control the VivoLink Controller by control device through RS232 port, it may be broken. Send it to an authorized dealer for repair.
Why there is a splash screen in output devices of VivoLink VLHDMICTL1-MME?
A splash screen appearing on the output devices of your VivoLink Controller might be due to the poor quality of the connecting cable. Try replacing it with a good quality cable.
General| Model | VLHDMICTL1-MME |
|---|---|
| Manufacturer | VivoLink |
| Interface | HDMI |
| Number of HDMI Inputs | 1 |
| Category | Controller |
| Compatibility | HDMI |
| Connector Type | HDMI |
To Next Page