Vivotek FD8161 - Page 129

VIVOTEK
User's Manual - 129
5: LOG_NOTICE
6: LOG_INFO
7: LOG_DEBUG
Group: camctrl
NAME VALUE SECURITY
(get/set)
DESCRIPTION
enablehttptunnel <boolean> 1/4 Enable HTTP tunnel for camera control.
Group: camctrl_c<0~(n-1)> for n channel product (capability.ptzenabled)
NAME VALUE SECURITY
(get/set)
DESCRIPTION
panspeed -5 ~ 5 1/4 Pan speed
tiltspeed -5 ~ 5 1/4 Tilt speed
zoomspeed -5 ~ 5 1/4 Zoom speed
autospeed -5 ~ 5 1/4 Auto pan speed
focusspeed -5 ~ 5 1/4 Auto focus speed
patrolseq string[64] 1/4 (For external device)
The indexes of patrol points, separated by “,”
patroldwelling string[128] 1/4 (For external device)
The dwelling time of each patrol point, separated by “,”
preset_i<0~(npre
set-1)>_name
string[40] 1/4 Name of the preset location.
preset_i<0~(npre
set-1)>_dwelling
0~999 1/4 The dwelling time of each preset location.
uart 0 ~ (m-1), m
is UART count
1/4 Select corresponding uart
(capability.nuart>0).
cameraid 0~255 1/4 Camera ID controlling external PTZ camera.
isptz 0 ~ 2 1/4 0: disable PTZ commands.
1: enable PTZ commands with PTZ driver.
2: enable PTZ commands with UART tunnel.
disablemdonptz <boolean> 1/4 Disable motion detection on PTZ operation.
Group: snmp (capability.snmp) (product dependent)
NAME VALUE SECURITY
(get/set)
DESCRIPTION
v2 0~1 6/6 SNMP v2 enabled. 0 for disable, 1 for enable
v3 0~1 6/6 SNMP v3 enabled. 0 for disable, 1 for enable
secnamerw string[31] 6/6 Read/write security name