0: off
1: auto
2: always on
3: keep current value
wdrc_strength 0~2 4/4 WDR enhanced.
0: low
1: medium
2: high
agc 0,1,2 4/4 Set auto gain control to normal level or MAX level.
0->2x,
1->4x,
2->8x
(not used in FD8162)
agcmode auto,fixed 4/4 Set auto gain control mode.
maxgain 0~100 4/4 Manual set maximum gain value.
mingain 0~100 4/4 Manual set minimum gain value.
autoiris <boolean> 4/4 Enable auto Iris.
(not used in FD8162)
7.10 IR cut control
Group: ircutcontrol (capability.nvideoinprofile > 0)
NAME VALUE SECURITY
(get/set)
DESCRIPTION
mode auto,
day,
night,
di,
schedule
<product
dependent>
6/6 Set IR cut control mode
daymodebegintime 00:00~23:59 6/6 Day mode begin time
daymodeendtime 00:00~23:59 6/6 Day mod end time
bwmode <boolean> 6/6 Switch to B/W in night mode if enabled
sensitivity low,
normal,
high
6/6 Sensitivity of light sensor
7.11 Image setting per channel
Group: image_c<0~(n-1)> for n channel products
NAME VALUE SECURITY
(get/set)
DESCRIPTION
brightness -5~5 4/4 Adjust brightness of image according to mode
settings.
saturation -5~5,100 4/4 Adjust saturation of image according to mode settings.
100 for saturation percentage mode.
saturationpercent 0~100 4/4 Adjust saturation value of percentage when
saturation=100
contrast -5 ~ 5 4/4 Adjust contrast of image according to mode settings.
sharpness -3~3,100 4/4 Adjust sharpness of image according to mode settings.
sharpnesspercent 0~100 4/4 Adjust sharpness value of percentage when
sharpness=100
gammacurve 0~100 4/4 Gamma curve.
lowlightmode <boolean> 4/4 Enable/disable low light mode.
profile_i0_enable <boolean> 4/4 Enable/disable this profile setting
profile_i0_policy day,
night,
schedule
4/4 The mode which the profile is applied to.
profile_i0_begintim
e
hh:mm 4/4 Begin time of schedule mode.
profile_i0_endtime hh:mm 4/4 End time of schedule mode.
profile_i0_contrast -5 ~ 5 4/4 Adjust contrast of image according to mode settings.
profile_i0_sharpne
ss
-3~3 4/4 Adjust sharpness of image according to mode settings.
profile_i0_sharpne
sspercent
0~100 4/4 Adjust sharpness value of percentage when
sharpness=100
profile_i0_gammac
urve
0~100 4/4 Gamma curve
profile_i0_lowlight
mode
<boolean> 4/4 Enable/disable low light mode.
profile_i0_wdrcstre
ngth
0~2 4/4 WDR enhanced
0: low
1: medium
2: high
profile_i0_wdrcmo 0~3 4/4 WDR enhanced
To Next Page
Loading...
