Vivotek FD8162 - Page 73

VIVOTEK
User's Manual - 73
If you want to congure another sensor setting for day/night/schedule mode, please click Prole to open
the Prole Settings page as shown below.
Please follow the steps below to setup a prole:
1� Check Enable and apply this prole�
2� Select the applied mode: Day mode, Night mode, or Schedule mode� Please manually enter a range of
time if you choose Schedule mode�
3� Configure the settings in the following columns� Please refer to the previous page for detailed
information�
4� Click Save to enable the settings and click Close to exit the page�
2011/03/13 17:08:56