10TA Service Manual
TROUBLESHOOTING
5/29/14
8-1
8. Troubleshooting
NOTE: With the exception of bin control, anytime the machine stops, it must be manually re-started
by pushing the "Start" push-button. If it stopped while in a freeze cycle, it will then start in a thawing
cycle.
Always check the machine thoroughly after remedying the problem to prevent the same cause from
reoccurring.
Symptom Page
Machine Won’t Run 8-2 & 8-3
Freeze-up Due To Extended Freeze Period 8-4
Freeze-up Due To Ice Failing To Discharge 8-5
Poor Ice Quality 8-6
Low Ice Capacity 8-7
Low Compressor Oil Level 8-8
High Head Pressure (Water Cooled Machines) 8-9
High Head Pressure (Air-Cooled Machines) 8-10
To Next Page
Loading...