Digital Storage Oscilloscope 41
The scope saves the waveform data in memory in “.lwf format.
3. Reference
The scope saves the waveform data in memory in “.REF” format. At recall, the
reference waveform will be displayed on the screen directly.
4. CSV
It saves the waveform data in external memory in “.CSV” format. The stored files
contain the waveform data of the displayed analog channels and the main setting
information of the oscilloscope. The recall of CSV file is not supported. Set the save
type to CSV, and set the Para Save option to On or Off to turn on or of the parameters
storage function.
Internal Save and Recall
Internal save and recall support Setups in Save/Recall. In the following part, the save
and recall method and procedures are introduced.
Save the specified oscilloscope setting in internal memory.
1. Connect the signal to the oscilloscope and obtain stable display.
2. Press [Save/Recall] button on the front panel to enter the SAVE/RECALL function
menu.
3. Press the Save softkey and then turn the Universal Knob to select Setup and then
press the knob to confirm.
4. Press the Save To softkey to select Internal to save the current setup of the
oscilloscope to the internal memory.
5. Press the SetUp softkey button, then turn the Universal Knob to select the location
to save. The internal memory can save as many as 9 setup files, from No.1～No.9.
6. Press the Save softkey to save the current setup to the appointed location. After a
few seconds, it will pop-out the message “Save successfully”.
Load the specified type of file in internal memory.
If want to recall the setup after having finished the steps above, please do the following
steps: Press the Recall softkey, and then turn the Universal Knob to select the
location that you want to recall, press the Recall softkey to recall the setup, and it will
pop-out the message “Recall Successfully”.
To Next Page
Loading...
Need help?
General
