Installation Category II: derate at 20dB/decade above 100kHz to
13V peak AC at 3MHz* and above. For non-sinusoidal
waveforms, peak value must be less than 450V. Excursion
above 300V should be of less than 100ms duration. RMS signal
level including all DC components removed through AC coupling
must be limited to 300V. If these values are exceeded, damage
to the oscilloscope may occur.
Voltage difference between cursors: △V
Time difference between cursors: △T
Reciprocal of △T in Hertz (1/ΔT)
Frequency, Period, Mean, Peak-to-peak, Cycle RMS, PRMS,
Minimum, Maximum, Rise Time, Fall Time, + Width, - Width, +
Duty, - Duty, Base, Top, Middle, Amplitude, Overshoot,
Preshoot, Pmean, FOVShoot, RPREShoot, BWidth, Delay 1-2
↑, Delay 1-2 ↓, LFF, LFR, LRF, LRR, FFR, EFRF
To Next Page
Loading...
