Oil Filter/By-pass Filter, Replace
Change the oil filters and by-pass filter at every oil
change.
Remember to bring the old filters to an authorized
recycling station.
WARNING!
Hot oil and hot surfaces can cause burns.
1 Put a suitable vessel underneath the filters to avoid
oil spill.
2 Clean the filter bracket.
3 Unscrew the bypass filter (1) and the oil filters (2)
with a suitable filter wrench.
4 Make sure the seal's mating surfaces on the filter
brackets are clean.
5 Lightly oil the rubber seal of the new filters.
6 Mount the new filters by hand until the gasket is in
contact with the sealing surface. Then tighten the
filters another 3/4 to 1 turn.
7 Start the engine (idle) and make sure that no
leakages occur. Check the oil level once the engine
has stopped.
Maintenance
47713726 12-2021 © AB VOLVO PENTA 111
To Next Page