Service and maintenance
Tyres 143
Tyres
Tyres, checking air pressure
Check the air pressure every 500 hours.
Regarding recommended air pressure, see page 187.
Tyres, checking wear
Check the tyre wear every 500 hours.
Tyres, inflating
Filler valve (A) on the machine may preferably be used for inflating
tyres or cleaning in connection with maintenance work. The filler
valve is positioned to the left behind the cab.
Connecting hose:
1 Remove the cover.
2 Connect the hose.
Wheel nuts, check-tightening
After replacement of a wheel or if a wheel has been removed for
other reasons, The wheel nuts must be check-tightened after 3
hours of operation.
Tightening torque: 800 Nm (590 lbf ft)
NOTE! Try to avoid mixing tyres from different manufacturers
or tyres with different type designations on the same axle, as
this may lead to unnecessary wear of the drive train and also
alter the properties of the machine.
WARNING!
Make sure that you stand to one side of the tyre when
inflating a tyre fitted on a split rim. Tyres fitted on such a
rim may explode causing injury or death. Use a self
attaching air chuck with a hose long enough to enable you
to be out of the trajectory path when filling the tyre with air.
V1052136
1044827
A
Filler valve
To Next Page
Loading...
Need help?
General
