Operating techniques
84 Transport operation
Transport operation
Q For all operation on roads with moderate inclines select gear
position D. The machine will then shift gears automatically
depending on need for traction power.
Q Utilise the maximum speed of the machine with sound
judgement.
Q Always adapt the speed to the road conditions and the traffic
situation in order to operate safely and comfortably.
Q Pay attention to the trailer unit's movements while operating.
Q On no account must there be any risk of part of the load falling
off when transporting.
Q Do not forget to disengage all differential locks, if you are
operating on a good road (firm surface).
Q Also remember that the machine, when fully loaded, may weigh
as much as 70 tonnes. This requires a long braking distance,
especially if the road is slippery or you are travelling at high
speed.
WARNING!
As the trailer unit frame is pivoted, relative to the tractor
unit frame, around a longitudinal, horizontal axis, you will
not feel, if the trailer unit should begin to tip over sideways.
Therefore, great care must be exercised when operating the
machine. Avoid operating fast round bends, on uneven
ground and on downhills.
When operating through a bend at high speed, you must
always bear in mind that there is a risk of overturning. The
risk of overturning increases when the centre of gravity of
the load is high or displaced to one side or if the bends are
sharp, cambered the wrong way or the surface is slippery.
To Next Page
Loading...
Need help?
General
