Travel
Starting the engine 45
Programming of access code for dealers, technical personnel
(freely programmable).
– Insert the ignition key into the ignition switch and turn it to posi-
tion "I".
– Enter the secret code, press key (E) and enter the numerical
v alue (6-digit) of your choice.
– Press key (E) to confirm this programming sequence.
For safety reasons this access code must be entered twice.
– Enter the access code (6-digit), press key (D) and start the
engine.
Programming of acc ess code for users, e.g. driver, r ental cus-
tomers (freely programmable).
– The access code (for dealers, technical personnel) must
already have been programmed.
– Insert the ignition key into the ignition switch and turn it to
position "I".
– Enter the access code (dealers, technical personnel) and press
key (E).
– Enter the access code for users (driver, rental customer) a
row of numbers (6-digit) of your choice.
– Press key (E) to confirm this programming sequence.
For safety reasons this access code must be entered twice.
– Enter the access code (6-digit), press key (D) and start the
engine.
When shutting the engine down (ignition key in position "0")
the immobilizer remains deactivated.
After 15 minutes the immobilizer is activated, after this the
secret code or the access code must be entered again to be
able to start.
If the immobilizer is to be activated immediately after shutting
the engine down (ignition key in position "0"), button (E)
must be pressed two times.
To Next Page
