Maintenance
Running-in instructions 65
Running-in instructions
– During the first week all wheel nuts must be tightened
every day, after this every 50 operating hours (tightening
torque 290 Nm / 213 lbf ft).
– After a wheel change the wheel nuts must also be tight-
ened every day during the first week.
First maintenance after 50 0 operating hours:
For further maintenance intervals refer to the lubrication and main-
tenance plan.
– Oil change in front/rear axle with splitter gear
First maintenance (also for service exchange and new compo-
nents).
To Next Page
