Ceramic Master Е1000 en v3 13
General errors
Errors concerning the heating
Errors concerning the movement of the table
Errors concerning the vacuum
1 - Missing signal "mains zero", entry 0
2 - Missing signal "mains zero", entry 1
3 - Mains frequency is not 50Hz or 60Hz.
15 - During running of a program: when the
temperature is increasing the needed rate of
increasing cannot be achieved.
19 - The required temperature is not reached for the
selected time.
20 - The required temperature can not be reached
during cooling.
21 - The selected temperature can not be reached
during heating.
22 - Temperature is higher than 1200°С.
23 - Temperature is lower than 5°С.
99 - Interrupted thermo sensor or the temperature is
higher than 1285°С.
53, 54 - The position sensor for the table is not reached
for a required during drying.
83, 93 - The position sensor for the table for drying is not
reached for the required time during opening.
84 - The upper position sensor of the table (closing)
is not reached for the required time.
78, 86, 94 - The lower position sensor for the table is not
reached for the required time during opening of
the furnace.
76 - The time for opening is over during the program
controlled mode.
90 - The upper position sensor for the table is not
reached for a long time in the MANUAL mode of
closing.
91 - The lower position sensor for the table is not
reached for a long time in the MANUAL mode of
closing.
28 - The selected vacuum is not reached for the
required time.
39 - low level of vacuum during the compression;
50 - There exists residual vacuum during the initial
power on procedure.
51 - After releasing the vacuum, for the required
time the vacuum is not released entirely.
75 - The vacuum can not be released in programming
mode.
Errors concerning RS232 interface to the PC
To Next Page
Loading...
