18
WWW.VORONDESIGN.COM
MGN9 ASSEMBLY TOOL
Fit the tool over the bearings on one side.
Squeeze the sides of the tool and rotate it
to t it over the other side’s bearings, then
release pressure.
The tool serves to hold the balls in place
when not installed on a rail, and will help
you reinstall the carriage later. Not bad
for a 7 minute print, right?
CAREFULLY REMOVE THE CARRIAGE
Do this over a bowl or other container, just
in case a ball drops out. If some do, don’t
panic! They can be pushed back in, just
add the balls back to the middle of the
carriage.
To Next Page
Loading...
