24
WWW.VORONDESIGN.COM
MAGNETS
DO YOU SMELL…GLUE?
Yes, yes you do. Specically superglue, but you could also use RTV silicone, just a drop. Is all that is needed.
Despite our best efforts, the magnets can still come loose without it.
MAGNET PRESS
1. Place magnet on a at surface (polarity doesn’t
matter)
2. Place a drop of CA glue on top of the magnet
3. Place magnet holder on magnet.
4. Using a strong at tool, rmly press magnet holder
down over magnet.
Do this for both left and right magnet holders.
Alternately you can use channel lock pliers (or a vise)
for this,. Whatever tool you use please go slow and
don’t crush the parts or your ngers!
(2) 6x3 magnets
2 drops RTV or Superglue
ROUND MAGNET, HEX HOLE
The magnet seats here hold much better than
a round hole. The seats have been carefully
designed and tested to maximize holding
power.
To Next Page
Loading...
