Vox StompLab IIB User Manual

11
buon aer the master volume ([GBL] VALUE2) appears on
the program/value display. “CP” will appear briey on the
program/value display and the volume can be changed by
using the expression pedal.
Setting the range of the parameter that will be used by
the pedal
Set the range of the eect parameter that will be used by the
expression pedal in the pedal seing mode.
1.
Press and hold the pedal seing buon for approximately 1
second.
The mode will switch to the pedal seing mode and the
expression pedal LED will blink.
2.
Set the value when the expression pedal is fully returned upright
with the VALUE 1 knob.
3. Set the value when the expression pedal is fully pressed down
with the VALUE 2 knob.
The tone will change within the set range when the pedal
is used.
4. When you nish adjusting your seings, press the pedal seing
buon to exit the pedal seing mode.
5. Enter the edit mode to save the seings.
 Page 12 “Saving a program — [WRITE]”
The set range will return to the previous seing if they
are not saved when the program is switched or when the
power is turned o.
If the program is saved aer using the expression pedal, the
position of the expression pedal (inclined) will be saved as
the set value.
The following values cannot be saved.
• Volume
• Input level to delay eect [PDL]
• Input level to reverb eect [REV]
• Pitch parameter of [MOD] PITCH SHIFT
To control the volume with the pedal, assign the
master level ([GBL] VALUE 2). To control the input
levels of the reverb and delay effects, assign MIX
parameters ([DLY] VALUE 2 and [REV] VALUE 2).
When a target function of the eect pedal is not available,
“- -” appears briey on the program/parameter display
and the pedal cannot be set.
Eect/parameter type and parameter value display
In the Edit mode you can switch the eect names or the VALUE
1 and VALUE 2 values indicated with the Program UP/DOWN
pedals. The tuner

LED will light up when the eect name is
indicated, the tuner center LED will light up when VALUE 1
is indicated and the tuner # LED will light up when VALUE 2
is indicated.
Checking the values saved in a program (Original Value)
The Original Value LED in the program/value display lets you
check the parameter values of a saved program.
When you use the knob or buons to modify the value of a
parameter, the Original Value LED will light up when that value

Vox StompLab IIB Specifications

General

Brand	Vox
Model	StompLab IIB
Category	Music Pedal
Language	English