13
Adjusting the sensitivity of the expression pedal
If the minimum and maximum values of the parameter are assigned
as the minimum and maximum values of the expression pedal,
but the eect or volume fails to reach the maximum (or minimum)
seing when the expression pedal is fully advanced (or returned),
you can adjust the sensitivity of the expression pedal as follows
so that it will function optimally.
When adjusting the sensitivity, you must use the expression
pedal with your foot; in some cases, it may not be possible to
adjust the pedal sensitivity if you use it with your hand.
1. Turn the power o.
2. While holding down the Expression pedal seing buon and
buon, turn the power on.
3.
When the program/value display indicates “Pd,” release the
buons.
4. Advance the expression pedal so that the eect switches on/o.
This will be assigned as the weight that will switch on/o the
eect assigned to the expression pedal.
5.
Use your foot to slowly return the expression pedal toward
yourself, and take your foot o when the pedal stops.
6.
Soly advance the expression pedal, and take your foot o
when the pedal stops.
If you decide to cancel this sensitivity adjustment, press
the switch.
7. Press the switch.
“CP” will appear on the program/value display and the mode
will automatically switch to the program select mode.
If the sensitivity adjustment could not be performed correctly,
the program/value display will blink “Er”, and will then
indicate “Pd”. In this case, perform the procedure from step 4.
If you are repeatedly unsuccessful in adjusting
the sensitivity, it is possible that the StompLab has
malfunctioned. Please contact your local VOX dealer.
To Next Page
Loading...
Need help?
General
