15
q Is the expression pedal fully returned when volume, [AMP/DR]
VALUE1 knob (GAIN) and VALUE2 knob (LEVEL) are set as the
target funciotn of the expression pedal?
3. Eects don’t apply
q Could an eect be o?
q
Is the [MOD] VALUE 2 knob (DEPTH) or the [DLY] or [REV] VALUE
2 knob (MIX) set to a low value?
q Is the StompLab in Bypass mode?
Refer to “Bypass and Mute” (p. 8) and cancel the Bypass function.
4.
High frequencies are distorted when using [PDL] (PEDAL)
AC (ACOUSTIC)
q Are you applying too much drive? Lower the [AMP/DR] VALUE
1 (GAIN) seing.
q Are you using a bass that has high output humbucking pickups?
Lower the volume of your bass.
5.
Sound source connected to the bass amp is distorted, or
sounds wrong
q Is the VALUE 1 knob (StompLab output jack connection volume)
in [GBL] set at Ln (LINE)?
Set to AP (AMP).
q Is the VALUE 2 knob (LEVEL) in [AMP/DR] or the VALUE 2 knob
(MASTER LEVEL) in [GBL] set too high?
Specications
Number of eects: Pedal types: 9
Amp/Drive Models: 18
Cabinet Models: 12
Modulation types: 9
Delay types: 8
Reverb types: 3
Noise Reduction: 1
Volume Pedal: 1
Number of programs: 120 (20 user/100 preset)
Audio input: INPUT (mono)
Audio output: OUTPUT/PHONES (stereo)
Signal processing: A/D conversion: 24 bit
D/A conversion: 24 bit
Tuner: Detection range : A0–E6
Calibration: A=438 – 445 Hz
Power supply: Four alkaline AA baeries or
DC9V AC adapter (separately
sold)
Baery life 7.5 hours (using four alkaline
AA baeries)
Dimensions (W X D X H): 207 X 125 X 64mm /
8.15" X 4.92" X 2.52"
Weight: 780 g / 1.72 oz.
Included items: Owner’s manual, four AA-size
baeries
Options (separately sold): DC9V AC adapter
* Specications and appearance are subject to change without notice
for improvement.