Vox StompLab IIB User Manual

14
Restoring the factory preset programs
Here’s how to restore (reload) the StompLab’s programs back to
the original factory preset programs.
When you perform this operation, all of the programs you
created and stored inside the StompLab will be erased, and
replaced by the factory programs.
1. While holding down the  buon and the  buon, turn on
the power.
2. The program/value display will indicate “ rL ”, and the TUNER
# and

LEDs will blink. Take your hand o both buons you
had been pressing.
If you decide to cancel the reload operation at this point, press
the  buon.
3. If you wish to reload the factory seings press the  buon.
The program/value display will indicate “ Ld ” and reloading
will begin. When reloading has completed, the program/value
display will indicate “CP ”, and the StompLab will automatically
enter Program select mode.
Never turn o the power while reloading.
Troubleshooting
If you suspect a malfunction, please check the following points. If
this does not resolve the problem, please contact a nearby dealer.
1. Power does not turn on
q Have the baeries have run down?
When the baeries run low, the program/value display will be dark.
We recommend that you replace the baeries as soon as possible.
If baeries become unusable, remove them immediately. Leaving
drained baeries in the unit can cause malfunctions (such as baery
leakage). You should also remove the baeries if you won’t be using
the StompLab for an extended period of time.
q Make sure the baeries are inserted with the polarities (+, -) in the
correct orientation.
q Is the AC adapter connected to the rear panel DC9V jack?
q Is the AC adapter plugged into an AC outlet?
q Could the AC adapter be damaged?
2. No sound
q Is the volume of your bass turned down?
q Is your bass cable connected correctly?
q Is your bass cable broken?
q Are the [AMP/DR] VALUE 1 (GAIN) or VALUE 2 (LEVEL) parameters
currently set to a low value?
q Are the [Lo/Hi] or [Mid] parameters currently set to a low value?
For some amp models, there may be no sound from the amp if the
LO, MID, and HI control values are low.
q Is the volume turned down for another eect?
q Is the Mute function activated?
Refer to “Bypass and Mute” (p. 8) and cancel the Mute function.
q Is the master volume turned down?
Set the CATEGORY selector to [GBL], and turn the VALUE 2 knob
to adjust the master volume.

Vox StompLab IIB Specifications

General

Brand	Vox
Model	StompLab IIB
Category	Music Pedal
Language	English