VTech BM3000 - Parent Unit Installation

14
2.6 Parent unit installation
Install the parent unit as shown below.
Make sure that the power outlet is not controlled by a wall switch. Bundle
the adapter cord neatly with the attached self-adhesive strap.
Notes
The parent unit power adapter is intended to be correctly oriented in a vertical or
oor mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Make sure the parent unit and the power adapter cord are out of reach
of children.
•
•
Parent unit
Power outlet not
controlled by a
wall switch
Parent unit
power adapter
Self-adhesive
strap
If the battery is
installed, the
light on the parent
unit turns on while
charging.
Raise the antenna for
better reception.