29
USING YOUR BABY MONITOR
4.8 Pair/ unpair CAM
4.8.1 Pair new CAM
The baby units and parent unit provided are already paired. If
you want to replace an old baby unit, the new baby unit must
be paired to the parent unit before use.
Make sure you power on the baby unit (see page 31) and the parent unit
(see page 33) before pairing.
To pair a baby unit:
On the idle parent unit, press M.
Press or to choose PAIR/UNPAIR CAM, then press M or .
Press M or again to choose Pair new CAM.
Press or to choose a desired baby unit slot, then press M.
If you choose an occupied baby unit slot, the new baby unit will
replace the existing baby unit.
Make sure the new baby unit is turned on. On the new baby unit,
immediately press and hold + and - for 5 seconds when the parent
unit screen displays Please press both [+] and [
-
] keys on CAM
side until POWER indicator ashes Red and Green light. The
light on the new baby unit ashes red and green alternately.
When pairing is successful, the screen displays the image from the
newly paired baby unit. The light on the new baby unit turns red
when it is powered by AA batteries or turns green when it is powered
by AC power.
Notes
If pairing fails, the screen displays Pairing failed. Try the pairing process
again.
Only one baby unit can be paired at a time.
4.8.2 Unpair CAM
Make sure you power on the baby unit and the parent unit
before unpairing the baby unit.
To unpair a baby unit:
On the idle parent unit, press M.
Press or to choose PAIR/UNPAIR CAM, then press M or .
1.
2.
3.
4.
5.
6.
•
•
1.
2.
To Next Page
Loading...
Need help?
General
