28
4.6 Sound-activated screen
When the parent unit screen is turned off manually (see page 34), you can
set the screen to be turned on automatically whenever there are sounds
detected from the baby units after 20 seconds of silence. The
parent unit screen will turn off automatically when no sounds
are detected from the baby units within 50 seconds. The sound-
activated screen is preset to Off.
To turn the sound-activated screen on or off:
Press M when the parent unit is not in use.
Press or to choose SOUND-ACTIVATED SCREEN, then
press M or .
Press or to choose On or Off, then press M to conrm your
selection. You hear a conrmation tone.
Notes
If you set the sensitivity level to Level 5 (Maximum) (see page 25), the baby
unit will be very sensitive and detect any sounds including background noises.
These background noises may disrupt the silence and prevent the sound-
activated screen feature to work properly.
The parent unit will turn on only if the sounds detected are from the last
viewed camera.
4.7 LDC brightness
You can change the brightness of the parent unit screen from Level 1 to
Level 5. The LCD brightness is preset to Level 3.
To set the brightness of the parent unit screen:
Press M when the parent unit is not in use.
Press or to choose LCD BRIGHTNESS, then press
M or .
Press or to choose the desired brightness.
Press M to conrm your selection. You hear a conrmation tone.
1.
2.
3.
•
•
1.
2.
3.
4.
To Next Page
Loading...
Need help?
General
