36
The video and audio monitor produces high-pitched noise.
The parent unit may be too close to the baby units. Make sure the
parent unit and the baby units are at least 1 metre away from one
another.
You may be too close to the baby unit when you press and hold TALK.
Make sure the parent unit and the baby units are at least 1 metre
away from one another.
You may have set the sensitivity level too high. You may need to
adjust the sensitivity level to a lower level to avoid audio feedback
(page 23).
The parent unit plays any sounds from the baby unit and I think it is
too noisy.
You may have set the sensitivity level to Level 5 (Maximum). If you do
so, the baby unit will transmit any sounds detected to the parent unit.
You may need to adjust the sensitivity level to a lower level (page 25).
You may need to adjust the speaker volume on the parent unit
(page 33).
The parent unit does not play any sound when there is noise from
the baby unit.
Make sure the parent unit is powered up by connecting it to AC power
(page 12) or to the rechargeable battery provided (page 15).
Make sure the parent unit is turned on (page 33) and the speaker
volume is not set to off (page 33).
Make sure the parent unit is not monitoring in multi-CAM mode.
The parent unit may be too far away from the baby unit. Move the
parent unit closer to the baby unit (but not less than 1 metre).
If the parent unit is powered by the provided battery, make sure there
is sufcient charge. Charge the battery in the parent unit for up to
12 hours.
You may have set the sensitivity level to a very low level. If you do so,
the baby unit will not detect sounds that is too soft or light. You may
need to adjust the sensitivity level to a higher level (page 25).
Large obstructions may impact the reception. Try to relocate the baby
unit, away from large obstructions such as walls and doors.
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
