VTech Innotab 3S - Install and Charge Batteries

4
Slide these switches to open the battery doors.
Always replace the InnoTab
®
3S battery doors
after changing batteries.
microSD Memory Card Slot Insert a microSD memory card (not included).
(NOTE: InnoTab
®
3S is compatible with
microSD memory cards up to 32GB.)
Battery Compartments Insert 4 AA batteries (not included) or the
rechargeable battery packs. For battery installation
instructions, please see the section below.
How to Attach the Stylus
Tie one end of the stylus string to the stylus and the other end to the stylus
fastener on the InnoTab
®
3S.
Battery Installation (For 4 AA batteries)
•Makesurethetabletisturnedoff.
•Locate thebattery doorlock sliding switchonthe back
of the tablet. Slide the switch to open the battery covers,
then remove the covers.
•Insert4AAbatteriesasshowninimage2.
•Makesuretoreplacethebatterycovers.
Installing the Rechargeable Battery Packs
1. MakesuretheInnoTab
®
3S is turned off.
2. Turn the unit over. Slide the battery door lock switches forward and push
the battery covers off to each side to remove them.
G
E
T
T
i
N
G
S
T
a
r
T
E
d
Battery Door Lock Sliding
Switches
2
1