VTech Innotab 3S User Manual

5
3. InsertBatteryPack①intothecompartmentontherightsideandBattery
Pack② into the compartment on the left side.
 •Insertthebatterypackintotheconnectorslotfirst.
 •Thenpressthebatterypackdownuntilitrestsinplace.
4. Replacethebatterycovers.
Charging and Recharging the Batteries
The rechargeable batteries should be fully charged before the first use. To charge
and recharge the batteries, please follow the instructions below.
1. Make sure the battery packs are installed in the tablet.
2. Use the VTech
®
AC adaptor (included) that complies with EN61558. Plug one
end of the AC adaptor into the power jack on the InnoTab
®
3S and plug the
other end into a wall outlet.
Note: The AC adaptor is not a toy.
This toy is not intended for use by children under 3 years old.
3. You can continue to use the InnoTab
®
3S while the AC adaptor is connected,
but the batteries will not charge while the InnoTab
®
3S is on. When you’re
done playing, turn the power off and leave the tablet connected to a wall
outlet to charge it.
4. The green light on the tablet will flash to indicate charging is in progress.
When the batteries are fully charged the light will turn off. A full charge takes
about 4.5 hours with the AC adaptor that’s included in the package.
Note: If the green light on the tablet flashes very quickly during charging, the
battery packs may not be connected properly. Please reinstall the battery
packs and try again.
Important Notes:
• Make sure the InnoTab
®
3S is turned off before charging.
• Thetabletwillchargeattemperaruresbetween5°C~35°C (41°F~95°F).
If the tablet is not charging properly, please move it to a location with a
suitable temperature.
G
E
T
T
i
N
G
S
T
a
r
T
E
d

VTech Innotab 3S Specifications

General

Brand	VTech
Model	Innotab 3S
Category	Tablet
Language	English