30
Appendix
30
Frequently asked questions
I have
manually or
accidentally
deregistered
my headset
from the
headset base.
You must register a new headset or the accidentally
deregistered headset to the headset base for it to
operate.
To register a new headset to the headset base:
Make sure the battery is properly installed in the
headset. The LED light flashes slowly in red and
blue to indicate the headset is not registered.
Place the headset in the headset base and allow
it to charge for at least one hour before beginning
registration.
Remove the headset from the headset base.
Press and hold the PAIR button for about four
seconds until the PHONE light on the headset base
turns on, and then release the button.
Return the headset to the headset base for
registration. The
LED
light
alternates quickly in red
and blue.
It takes about 60 seconds to complete the registration
process. Once the headset is registered, The
LED
light turns red when the battery is low and being
charged, or turns purple when the battery is well
charged, or turns blue when the battery is fully charged.
If the registration fails, you hear the voice prompt "Not
registered" when you press
the
ON/OFF button on the
headset, and the ON/OFF button light on the headset
alternates slowly in red and blue.
1.
2.
3.
4.
5.
To Next Page
Loading...
Need help?
General
