Checking the engine oil
Check the engine oil level using the dip stick.
(Refer to your engine manual for details)
DINGO K94 - SERIES I, II, III Revision 1.3 September 2020
Page 10
IMPORTANT: It is preferable to blow out dirt
than to wash it out. If water is used, keep it away
from electrical appliances
IMPORTANT: Do not high pressure wash. High
pressure washing can damage the electrical system.
Remove Debris
from the Machine
IMPORTANT: Overheating will result if the
engine is operated with a blocked grass screen,
dirty or plugged cooling fins, and/or cooling
shrouds removed.
The hydraulic system will keep cooler if the
machine is free from debris on the hydraulic tank
and fittings.
Park the machine on a flat surface, lower the
Dingo arms and turn off the engine. (turn ignition
key to off). Remove the key.
Check air filter pre-cleaner for debris. If required, wipe away
debris before and during each use.
Debris can build up in the engine area. Remove sides
of engine bay and clean any debris build-up with a
brush or blower before each use.
•970mm] general purpose - suitable for
grassy areas, dry soil and paved surfaces -
minimum ground disturbance.
• 8” lug tyres [machine width - 970] tractor
type, for building sites, and muddy situations.
•20 x 8” sand tyre [machine width - 1020]
better floatation & clearance for sandy & loose
material conditions.
• 5” forklift type tyres [machine width -
810mm] narrower tyres, suitable for heavy
loads, restricted access, inside buildings, great
on all hard surfaces.
•3” narrow solid tyres [machine width -
760mm] only for very restricted access - will fit
through a standard doorway.
Tyres and Traction
The correct tyre pressure is usually between
172
and 241 kpa (25-35psi). (Use lower pressures
for soft ground conditions & higher pressures for
hard ground conditions) Use of incorrect tyre
pressure will reduce the stability and carrying
capacity of the Dingo.
Filling the tyres with water can improve the
Dingo‟s stability for lifting applications. Water
filling equipment can be purchased from Dingo
Australia.
This range includes:
•8” Dingo tyres [machine width 970mm]
Specially designed for Dingo these 18"x8" tyres
feature a unique tread pattern for excellent
performance in a range of conditions, 6 ply for
strength & stability and a compound designed
for durability.
• 8” turf tyres [machine width
•Tracks [machine width - 1100mm] excellent
floatation and traction - suitable for mud, sand and
slush.
• Solid fill (all of the tyres mentioned above
(excluding the 3”solids) can be supplied by
Dingo Australia, filled with a puncture-proof,
solid foam).
For more information on our range of
traction products, please speak to your
nearest Dingo representative
To Next Page
Loading...
