Control Panel Diagram
DINGO K94 - SERIES I, II, III Revision 1.3 September 2020
Page 12
1. Drive control levers
2. Attachment tilt lever
3. Loader arms lever
4. Auxiliary hydraulic lever
5. Pump selector valve
6. Throttle
7. Ignition
8. 4 in 1 Bucket Lever
9. Flow Divider
10. Hydraulic Immobiliser
11. Warning Light
12. Auxiliary Power Socket
When faster attachment speed and power is re-
quired (trenching, post hole digging etc) more than
ground speed and lifting power, push the pump
selector lever to the forward position (Turtle).
4in1 Bucket Lever
The 4in1 bucket lever opens and closes the 4in1
bucket. Push the lever forward to open the bucket.
Pull the lever backward to close the bucket. When
you let go of the lever it will return to the centre and
hold the bucket it the current position
Hydraulic Immobiliser
Each Dingo K9-4 is fitted with a security hydraulic
immobiliser. This immobiliser locks the hydraulic
system allowing no oil flow to the wheels, thus
making it impossible to drive the machine away.
To engage the immobiliser:
1. Push the flow divider all the way forward
2. Push in the immobiliser lock
The flow divider is now locked into position
allowing no oil flow to the wheels.
To unlock the immobiliser:
1. Unlock the immobiliser lock using the key
Auxiliary Hydraulic lever
The auxiliary hydraulics lever allows you to alter
the direction of rotation of hydraulically driven
attachments or stop them completely.
ATTENTION: Ensure auxiliary hydraulic lever is
in neutral position before starting engine. Aside
from starting difficulties the attachment may move
during starting.
To operate attachment in forward direction, slowly
pull auxiliary lever rearward. To operate
attachment in reverse direction, slowly push
auxiliary lever forward.
Pump Selector Lever
When faster ground speed and lifting speed is
required (bucket work) more than attachment
speed and power, push the pump selector lever to
the rearward position (Hare).
2. Wriggle the flow divider lever to release
the lock from the flow divider
3.
Move the flow divider lever back to the
drive position
Warning Light
The warning light indicates low engine oil
pressure and high engine temperature. Ensure you
stop the engine immediately this light comes on.
Operating with the warning light on may cause
serious engine damage.
Auxiliary Power Socket
The auxiliary power socket is a 12 volt power
outlet for running lights, portable air compressors
mobile phone chargers etc. Power is available
from the socket when the ignition key is in the ON
position. To turn power off turn the key to the
OFF position
To Next Page
Loading...
