14. Stop engine, allow to cool and drain the
fuel tank; refer to section on Fuel Tank.
DINGO K94 - SERIES I, II, III Revision 1.3 September 2020
Page 20
15. Restart engine and run it until it stops. Repeat,
on “CHOKE” until engine will not restart.
16.Dispose of fuel properly. Recycle according to
local codes NOTE: Do not store
stabiliser/conditioned petrol over 90 days
17.Check and tighten all bolts, nuts screws.
Repair or replace any part that is damaged or
defective.
18.
Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place. Cover the
machine to protect it and keep it clean.
Transporting and
Securing
IMPORTANT: Do no operate or drive Dingo
on roadways
IMPORTANT: When transporting your Dingo
on a trailer, always use the following procedure.
1.Never load or unload the Dingo on the trailer
unless the trailer is attached to the vehicle.
2.Always climb the ramps with the heavy end of
the machine up hill. E.g. With heavy
attachments like the trencher or backhoe attached
to the Dingo, climb the ramps in the forward
direction. With no attachment on the Dingo,
climb the ramps in the reverse direction.
3.The bucket, post hole digger and leveller
attachment should always be positioned in their
designated positions on the trailer. This will
help ensure that the weight is distributed
correctly on the trailer.
4.Ensure the load is positioned so that there is
more weight forward of the trailer axle than
behind the axle. Too much weight behind the
axle may cause the rear of the vehicle to become
too light.
5.Once in position on the trailer lower the
Dingo arms
6. Turn the key to Off to stop the engine.
7. Secure the machine to the trailer with chains
or straps using the tie down points on the Dingo
arms.
8. When towed by a vehicle not fitted with an
electric trailer brake controller, engage the
manual breaking system by lifting the manual
override stopper on the tow coupling (single axle
trailer only).
To Next Page
Loading...
