Operation
T01044GB 21
6.3 Starting
1. Leave the machine’s safety zone.
2. Point the sender toward the receiver eye (a).
3. Hold the starter button (i) depressed until the vibratory plate runs.
4. The motor will automatically assume the standard speed when at
least one of the two joysticks (g) is moved from the center position.
Wait until the engine stops before repeating the starting procedure.
Only start upthe engine with a connected battery, so as to avoid
damages to the dynamo. Disconnect the negative pole when carrying
out welding jobs.
a
g
g
i
To Next Page
Loading...
