Faults
T01052GB 32
The machine can be started, but does not move – LED ring (b) blinks
rapidly
8.3 Forward speed too low
8.4 No reverse motion
8.5 Loss of hydraulic oil
Contact the Wacker Service in case of additional failures.
Cause Remedy
The operator is standing in the
machine’s safety zone.
Operator must leave the safety zone.
Cause Remedy
To little hydraulic oil in the centre pole
head.
Top up hydraulic oil.
Air in hydraulic control. Bleed system.
Cause Remedy
Mechanical fault. Contact Wacker service dept.
Cause Remedy
Leaks, hydraulic hose defective.
Change defective parts.
Note: Bleed system after every
dismantling operation.
To Next Page
Loading...
