E 2200, E 3000ES Maintenance
wc_tx001670gb.fm 91
7 Maintenance
7.1 Periodic Maintenance Schedule
The table below lists basic machine maintenance. Tasks designated with check
marks may be performed by the operator. Tasks designated with square bullet
points require special training and equipment.
Refer to the generator manufacturer’s operation manual for generator maintenance
procedures.
Task
Interval*
(hours of service)
Daily 2 Week Yearly
--- (50) (1200)
Inspect hose couplings.
3
Clean quick-connect
couplings
3
Inspect hoses and
connectors.
3
Inspect electrical cords/
connections.
Check/adjust burner air
setting.
Check HTF level. Fill if
necessary.
3
Check/adjust fuel pressure.
Check/adjust electrodes.
Replace burner nozzle.
Clean HTF strainer.
Replace fuel filter.
Lubricate hose reel chain.
Lubricate hose reel
bearings.
Clean turbulator tubes.
Inspect rope gasket.
Test the burner exhaust and
adjust the settings.
As needed or upon changing job sites
* Use whichever comes first, calendar time or service hours.
To Next Page
Loading...
Need help?
General
