EasyManuals Logo

Wacker Neuson E 2200 User Manual

Wacker Neuson E 2200
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #92 background imageLoading...
Page #92 background image
Maintenance E 2200, E 3000ES
92 wc_tx001670gb.fm
7.2 Repairing a Hose
Requirements
Hose nipple
Two hose ferrules
Hose crimping tool, part number 0169002
Procedure
Follow the procedure below to repair a damaged hose.
1. Shut down the machine and allow the Heat Transfer Fluid (HTF) to cool.
2. Locate the damaged portion of the hose and clamp locking pliers on either side
of the damaged portion.
3. Cut away the damaged portion of the hose (a) using a utility knife or similar tool.
4. Install a ferrule (b) on each end of the freshly cut hose.
5. Insert a nipple (c) into one of the ferrules.
NOTICE: Do not use petroleum to lubricate the nipple. If lubrication is needed, use
HTF.
6. Insert the free end of the nipple into the second ferrule. Be sure to push each
end of each hose to the lip of the nipple.
This procedure continues on the next page.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson E 2200 and is the answer not in the manual?

Wacker Neuson E 2200 Specifications

General IconGeneral
BrandWacker Neuson
ModelE 2200
CategoryHeater
LanguageEnglish

Related product manuals