Operation E 2200 / E 3000ES
52 wc_tx001667gb.fm
4.19 Rewinding the Hoses
Requirements
All accessories off, if applicable
Machine turned on
Procedure
Perform the procedure below to rewind the hose.
Note: Having warm HTF circulate through the hose will aid in rewinding of the
hose. Rewind the hoses with the burner firing.
1. Turn the T-handle (a) counterclockwise to unlock the hose reel.
2. Remove the foot pedal (b) and place it on a firm, flat, and dry surface.
3. Move Pump 2 ON-OFF switch (c) to the ON position.
4. Move the hose rewind ON-OFF switch (d) to the ON position.
Note: The rewind motor will start but will not rotate the hose reel until the clutch is
engaged.
5. Press down on the foot pedal to engage the clutch. The hose reel will rotate.
6. Guide hose loop 2 evenly onto the hose reel as it rotates.
This procedure continues on the next page.
CAUTION
Hot surface hazard. Hoses may be very hot.
f Wear hand protection while handling hoses.
wc_gr007885
a
wc_gr007886
b
wc_gr007892
wc_gr008064
c
d
To Next Page
Loading...
Need help?
General
