E 2200, E 3000ES Maintenance
wc_tx001670gb.fm 95
7.4 Inspecting Electrical Cords
Requirements
Machine stopped
Circuit breaker off
All power disconnected from machine
Procedure
1. Open all access doors and remove all access covers.
2. Inspect control panel and associated electrical cords for wear and/or damage.
3. Inspect pump and associated electrical cords for wear and/or damage.
4. Inspect hose reel and associated electrical cords for wear and/or damage.
5. Inspect burner and associated electrical cords for wear and/or damage.
6. Repair/replace any worn or damaged cords. Refer to your Parts Book for
replacement parts.
To Next Page
Loading...
