Disassembly/Assembly Procedures GP Repair
wc_tx000549gb.fm 112
7.6 Replacing the Fuel Tank
See Graphic: wc_gr003137
Removal:
7.6.1 Disconnect the spark plug.
7.6.2 Turn the fuel valve (a) off. Remove the fuel hose (b) at the fuel valve;
plug the fuel hose as soon as it is free from the fuel valve.
7.6.3 Remove the shoulder bolts (c) and hardware that secure the lifting
handle (d) to the frame and remove the lifting handle.
7.6.4 Remove the two nuts (e) that secure the retaining bracket (f) to the
frame and remove the retaining bracket.
7.6.5 Remove the four screws (g) that secure the tank (h) to the frame and
lift the tank up and out of the frame.
Installation:
7.6.6 When installing the fuel tank (h), screw in slightly the two screws (gg),
located near the control panel, used to secure the fuel tank. Tape the
washer in the raised position to the screw. Then, slide the fuel tank
underneath the washer. Tighten all the screws securing the fuel tank
to the frame.
7.6.7 Secure the retaining bracket (f) with two nuts (e).
7.6.8 Position the bushing, spacer, and washer as shown and secure the
lifting handle (d) to the frame with the shoulder bolts (c).
7.6.9 Reinstall the fuel hose (b).
7.6.10 Reconnect the spark plug.
To Next Page
Loading...
Need help?
General
